How To Curl A Wig With Sponge Rollers And A Blow Dryer
We’ve started with a teal, layered wig. Try to search out wigs which are good and full – you don’t need clean spots in between your ringlets.
Place the wig on a styrafoam block and secure it with t-pins. We like using a camera tripod for a base – it’s fully adjustable and can rotate. Here is what you’ll need:
– wig block
– wig stand (we used a digital camera tripod)
– sponge rollers
– blow dryer
– clip and/or ties to part off hair
Step Two: Sections
Subsequent, pull up all the wig hair, aside from a few tracks close to the bottom. That is the primary section you’ll be curling. We like to separate each section by the track lines (as pictured).
Step Three: Roll It Up
Roll a small section of hair onto one of the sponge rollers. Be careful to keep the rolled hair as neat as potential – the more time you set into rolling the hair nicely, the higher your ringlets will look once you unroll them.
Step Four: Secure It
Each sponge roller has a latch. After you’ve rolled your hair part completely, secure the latch. If the roller doesn’t keep in place, you’ll must re-roll the hair a bit tighter.
Step 5: Repeat
Continue rolling small sections of hair onto sponge rollers. As you go alongside, strive to keep each section and roll as neat as attainable.>
Step Six: Add Some Heat
Hold the blowdryer over every roller for about 60 seconds. We don’t recommend heating each roller for longer than 60 seconds. We put the heat setting on heat and airflow setting on excessive.
Be aware: When you apply too much heat, you will end up with “ratty” looking curls – numerous stray, kicky hairs.
Step Seven: Repeat
Don’t take out the curlers but! Roll up the rest of the wig.
Word: If you take out the ringlets as you progress up the wig, certainly one of two things will happen.
1. The heat of the blow dryer will relax the ringlets you’ve already taken out.
2. The air movement of the blow dryer will agitate the ringlets you’ve already taken out and can make them look messy.
Step Eight: Unroll
As soon as you’ve rolled and heated all the wig, go ahead and remove each roller. Try to be gentle as you do this and of course, make sure the curls have cooled down a bit earlier than removing them.
Step 9: Keep Unrolling
As an alternative of just pulling the roller out of the hair, attempt to gently “unwind” the roller. You’ll end up with nicer looking ringlets.
Step Ten: Ringlets
Now you’ve some lovely ringlets! As you can see, there is a huge difference in the way in which the wig hair seems to be! Undo the rest of the wig.
Step Eleven: Finished!
We did a little bit mild teasing once we unrolled all of silver gray hair extensions our ringlets, but you get the fundamental idea. Have enjoyable and be inventive!
Thanks for reading my tutorial! In case you have any additional questions, don’t hesitate to contact me at:
Disclaimer: If you’ve never finished this before, have some common sense and take a look at this out on a wig you don’t mind possibly destroying. Check out a small part of hair earlier than committing to curling an entire wig. Don’t use a blow dryer near bath tubs full of water. Turn off the blow dryer when you’re completed.
When you cherished this article and also you would like to acquire more information regarding weave i implore you to stop by the web site.