How To apply Silicone To A Wig Cap
The cap of a wig is the bottom materials to which the hair, whether or not actual or synthetic, is attached. Applying silicone-based adhesives to the cap retains the wig in place, holding your pure hair flat and making wig software that much simpler, in addition to preventing embarrassing shifts and misalignment.
Skin and Hair Prep
To make your wig sit appropriately on your head — and keep there — you may want to arrange its surroundings first. First, pull your hair back as tightly as it can go. Safe it with bobby pins or a hair tie, depending in your wig and the look you need. Trim or shave away any baby hair close to your hairline, since you don’t need these displaying in opposition to a wig of a probably totally different coloration. Finally, wipe down your forehead with rubbing alcohol or astringent, clearing the way for the silicone adhesive to get a solid grip.
Apply a pores and skin protectant — obtainable from the place you bought your wig or from most major drugstores — along the realm where you want the cap to take a seat. This is especially essential if you happen to happen to have delicate skin. If you want to test the silicone adhesive first, apply a bit of on your bicep area, leaving it in place for a minimum of a day. If no rash or pink spot begins to kind after 24 to 36 hours, you’re in all probability within the clear.
Use a cotton ball to apply isopropyl alcohol to the area where the adhesive or tape will likely be positioned. This removes excess dirt and oil from the realm, guaranteeing correct adhesion. Use a make-up brush to apply the silicone adhesive around the area on the hairline where the cap will lay. Some adhesives need to get tacky first — take a look at the instructions on the again of the jar or bottle earlier than utility — then pull in your wig. Make nice adjustments to the cap, placing the seam at secret hair dye the hairline and visually aligning it horizontally with your eyebrows, then press around the perimeter of the cap. You may as well take extra security measures, reminiscent of applying wig tape in strategic areas as needed.
Silicone adhesives normally last about six weeks. Once you need to take away the wig, you will want to do so utilizing a specialized adhesive remover. Apply the remover by spraying it liberally over the edge of the cap where it’s attached to the glue and your head. Wait a couple of minutes for the glue to soften. Peel back the edge barely, applying extra remover directly to the joined area with cotton swabs. You solely need glue to remain on you, not the cap itself. This is applicable equally when removing wigs. Snip out stitching if you did this as well. Pull off the cap, together with any tape you could have additionally applied. If you’re successful, no glue will remain within the cap’s weave.