Boutique Hair Bow Tutorial
I did starch my ribbon prior to beginning this bow.
Take the ribbon (I’m utilizing 1 1/2″ ribbon on this tutorial) and make the form shown above, all the time be sure to maintain the “right best hair oils for damaged hair side” (ie- printed aspect up in heart). Be certain that the lengthy aspect of the ribbon is in the again with the longer facet of the ribbon hanging all the way down to the left.
Carry the long facet of the ribbon up over the present ribbon in order that the lengthy facet of the ribbon is now up and to the right.
Take the long aspect of the ribbon (that is up and to the fitting) and produce it back down BEHIND the highest piece of ribbon in best hair oils for damaged hair the center of the bow. The long piece will now be hanging down towards the middle of the bow.
Take the piece of ribbon that was hanging down in direction of the center/left backside and bring it to the higher left facet of the bow. This could be an excellent time to make any changes to your bow to make sure all of the loops are even.
Step 5) Turn your bow sideways (horizontal) and in the middle fastidiously fold the bow (see image above). For wider ribbon you must fold it in order that there are 3 peaks in the middle.
Utilizing your tremendous gauge wire tightly wrap the wire round the center of the bow and twist it on the again aspect of the bow and trim off the long items. Press the wire down so it’s not sharp.
Singe one end of the smaller ribbon (I at all times use an extended candle lighter- fray verify is costly and I’ve discovered it to not work as well) to prevent fraying and beginning on the again of the bow where the wire is tightened and reduce off, glue one finish of your small ribbon. Wrap the ribbon round the middle of the bow. Trim off excess ribbon and singe again and glue down on back of ribbon. It’s essential to fully finish the bow prior to attaching it to the clip. Particularly for the alligator clips. Some clips are made with the center ribbon wrapped around your complete clip and this causes the clip to not shut completely and the clip won’t stay in as properly. This way the “seal” on the clip is tight.
Tear off a piece of the wax paper and fold it over several instances. Clip the alligator clip to the wax paper and cargo the clip (the angled facet) up with sizzling glue. And stick your bow to the glue lined clip. Permit the glue to dry utterly after which peel away the wax paper that is in the clip. Trimming away any excess that can be seen from the front of the bow. This should depart a really smooth and even surface contained in the clip so that it will hold the hair! Trim and singe the ends of the ribbon with the lighter… watch out though… simply barely get the top of the ribbon near the flame… the ribbon will turn black if burnt.